seat to move. They fit tight for safety and to avoid rattles. Once the seat moves, usually all at once and quite loudly, lift the seat straight up out of the floor channels. Don't set the seat on your
...(front and back) fit in a 1996 Chevy Tahoe? Are the bolt locations the same in both trucks? The front seats I know will work but as far as the back seats they wont because the shape of the
Question about Cars & Trucks
...putting the seats back in place they are a tight fit, check underneath to make sure nothing bent then place carefully over the catches and with pressure down and back, they should click right
...car. There is no release on the either side of the back seat to remove the back of the seat. How can you get into the trunk from the back seat? try the key again as put the key in several times then ...
Question about Seat Cars & Trucks
...seat and not dropping the tank? The only way to find out is to lift the base of the rear seats and see if there is an access panel fastened in the floor. Some are push fit and others are screwed into ...
Question about Seat Cars & Trucks
...car mats for my chevy spark- they were advertised that they would fit. They don't. I used the front seat set this winter because I was desperate and am fine with keeping those. I didn't try until ...
...fit but don't force it. If it won't go all the way down, the shaft may not be lined up with the oil pump. A long screwdriver can be used to turn the oil pump to line up if needed. If it doesn't line ...
...seat on drivers side and cannot find how to see what the heck is leaking what is the best procedure to figure out what is leaking there? Thanks, Rick you most likely have a brake line rusted threw, ...
...seat for the ring is clean. Do not use silicone or any sealer when putting it back together. If it gets into the unit, it can cause major problems. Don't bother trying to use glue etc on the ...
...seat. The switch is on the rear top of the engine sort of midline but to the drivers side a little. There's a wiring harness that may hide it. If you didn't buy the socket that fits the oil pressure ...
224 questions posted
Usually answered in minutes!
196 Questions
175 Questions
170 Questions
128 Questions
115 Questions