...side rear axle is leaking. I need to know how to adjust the shims on the ring in pinion ? well if the axle is leaking you dont need to adjust the shims, it needs a new seal. pull the brakes off open ...
drivers side seems quite happy where it's at. I've tried a 4' bar, the 5# slide hammer on the flange - nothing! any ideas? place tye rod poper between trans and axel and lightly tap may pop o ring and
...It'll come out. The drivers side half axel won't come out on a 04 gmc 1500 4x4 it's still in the pig what is going on is the snap ring that strong you will brake the case trying to get it out
Question about Chevrolet Cars & Trucks
...side) 3. Remove shocks ( or just diconnect at either end) 4. disconnect driveshaft at axle and leave in trans (if possible) to prevent fluid loss. 5 Axle can now be removed by either removing the ...
Question about Chevrolet Silverado 1500
Can I remove the front, driver side, drive axle along with the front drive shaft and run without removing the pass. side drive axle? AWD model Chevy Trailblazer. Not a jeep! moved yah.
...drivers side hook your slide hammer to the axle flange and beat the #$@% out of it. tryy not to pry on the housing it is easy to break. good luck my dad has a 8 lb slide and he has been sliding away ...
Question about Chevrolet Silverado 1500
side cv axle from a 2005 Chevy asteo van AWD permenanlry The CV axle stub (end with the axle nut on it) supports the wheel bearing, removing the axle then driving on it would cause the bearing to wear
Question about Chevrolet Silverado 1500
...transmission Under the aluminum side cover it the transmission. It's on the drivers side. The drivers side axle must be removed to the side cover off. The solenoid is accessible once the cover is
Question about Chevrolet Cars & Trucks
...side axle n now it's leakin fliud If you didn't change the seal while the axle was out, chances are, THAT'S the problem. Depending on the mileage, the seal may have gotten hard and brittle. When the ...
Question about Chevrolet Silverado 1500
...axle nut. (this is a large nut, maybe 19mm or even bigger. these can be tough to get off sometimes without an air gun.) 3. Remove cotter pin and nut from the lower ball joint. 4. You can first try ...
2,477 questions posted
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions