1981 Chevrolet Corvette "pedal car" Questions

Ad

Question about Chevrolet Corvette

1 Answer

...pedal going to the floor either there is air in the lines or fluid is slowly leaking.If it is a small leak on one of your wheel cylinders, it may be hard to detect without pulling the wheels off and ...

Ad

Question about Chevrolet Corvette

1 Answer

89 corvette clutch pedal safety switch have to depress clutch pedal real hard in order to get safety switch to allow engine to crank should be adjustable. if its on top of pedal arm try adjusting it ...

Ad

pedal switch. After about ten minutes of no sound turning the key, the car finally started. If this is the problem, step by step instructions to replace the switch would be helpful. Or, is it possible

Question about Chevrolet Corvette

1 Answer

...replaced the master cylinder. I bled it as instructed and bled all the wheel lines. I have a good pedal until I start the engine. It must be a vacuum problem. Where do I start??? Sounds like your ...

Question about Chevrolet Corvette

1 Answer

...Thanks Larry L not sure this is the right answer but how much movement have you got with the clutch pedal before you feel any resistance...if its a couple of inches has the pedal stop rubber fallen ...

Question about Chevrolet Corvette

1 Answer

pedal. Throttle closes completely if the car is not running but when running if you just gently let of the gas the idle is about 1000 rpm then if you gooose the gas pedal and let it snap back the idle

Question about Chevrolet Corvette

1 Answer

...car is turned off and restarted the brake pedal comes back to like it is suppose to be.. probably a vacuum leak in a hose or the canister itself, you have bled all air out of system at each wheel ...

...car is running poorly and missing when hitting the gas pedal My 1989 Corvette is hard to start - takes alot of pumps of the gas pedal and then is missing and sometimes backfires on hitting the gas ...

Question about Chevrolet Corvette

1 Answer

...menu. Bleed the base brake system. Follow the scan tool directions until the desired brake pedal height is achieved. If the bleed procedure is aborted, a malfunction exists. Perform the ...

car was hard starting missing only stayed running when feathered pedal then noticed driver side exhaust pipe got cherry red Check to see if the exhaust is exiting the rear tailpipe. Could be a plugged

Not finding what you are looking for?
Cars & Trucks Logo

257 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...