...bad ujoint. i agree bad u joint but u need to block the wheels and put it in neutral then grab the driveshaft and pinion that is where the ujoints connect the driveshaft to the diff and also ...
Question about Chevrolet Silverado
...Jacked the front end up and put truck in 4wd and tires spin freely. Any suggestions?? Does the driveshaft for the front wheels turn when in 4wd? The actuater might work but the diff lock for the ...
rotated & balanced tires. new driveshaft & center carrier bearing u-joints new shocks front & rear replaced rear axle bearings and seals new left rear rotor parking brake shoes new disc ...
Question about Chevrolet Silverado
I have leakage out of rear transmission at driveshaft on a 2006 Chevy Silverado automatic, v6 engine over loaded in bed and towing a trailer. Now it slips when engine warms up. I'd take it to a ...
...an HD automatic transmission on a 2002 Chevrolet silverado 2500 with 4 wheel drive? remove both driveshaft's then transfer case and wiring, then transmission, is not a hard job but if you don't ...
...shut off I got under the truck while my brother spun the front tires and I couldn't hold the front driveshaft from spinning. This makes me think the actuator on the front drive is good. Oh when I
Question about Chevrolet Silverado
...rocking back and forth on front driveline to transfer ca how much rocking back and forth on front driveshaft on 2001 Chevrolet transfer case should there be? This is the 5.3 liter. clockwise or ...
Question about Chevrolet Silverado
and guide you a bit.To determine the ratio:How many rotations of the wheel does it take to make the driveshaft go around one time? 2 3/4 turns of the wheel for 1 turn of the driveshaft is a 2.75
Question about Chevrolet Silverado
...driveline jack up rear of truck and secure it put trans in neutral and go under vehicle and move driveshaft up and down and spin it back and forth see if there is any play the reason for jacking
have to measure from where the tail shaft bolts to the main transmission case. If you mean the T400 driveshaft sliding into the 700R4, then it shouldn't be a problem. Hope this helps. No the 400 shaft
116 questions posted
Usually answered in minutes!
1,100 Questions
795 Questions
556 Questions
393 Questions
396 Questions