2005 Dodge Ram 1500 "chain hard pull spark plug" Questions

...chain saw. It is so hard to pull start is there a pressure relief valve? I clamp it down to pull it. I answered this yesterday! It would have been better to give me the answer to the model number ...

hard way. Take #1 plug out and have someone bump the starter while you hold your thumb over the plug hole. You'll know when its a tdc cause it'll blow your thumb off. When youve got it close, turn the

...hard to start and very rough idle.changed coil,points condenser and replaced both wires to the coil.Now starts(but not always)and idles ok but misses like mad when revs are increased.Has good fuel ...

...chain.When we set th etiming at 2 BTDC it pings when you step on the gas at any speed,then when you road set it and stop the pinging,it will hardly pull itself.What should it set at to work properly ...

...chain breaks there are signs of wear, and it isn't hard to check for them. If your Jeep Cherokee is showing some of the signs, it is time to replace the timing chain. Timing Chain Function The timing ...

...chain jumped because of worn teeth or the gear on the distributer might be worn as well . i would check this first. you can always pull the valve covers to check the rockers to make sure they are not ...

...hard.Repaced starter,same problem.Checked timing chain,marks both up,balancer at 0deg,distributor at #1. What else can l check? what happened the last time it ran did it run hot or ?? Check the oil - ...

...hard. If your not in good health and can't take the shock of a plug wire don't try this have a shop do the work with a scope and othe r tools it's not pratical for you to own unless your working on ...

...chain , could the computer be at fault, if i set distibuter one tooth of it runs better but very hard starting, acts like computer cant adjust for the diffrence in timing of cam and crank Usually the ...

...hard. the coil made by NGK has numberS on them. 1>4 ,3>2 now trick #1 wasted spark wires must be tested 1 by 1. if you pull 2 off you just killed dead 2 sparks or 4. the HV side is wired in ...