...original VIN on your Vehicle. I don't think the dealer would program your keys to a mismatched VIN number, so more than likely you will need your ECM reprogrammed with the proper VIN. This will need ...
Question about Ford Cars & Trucks
...Program Failure PCM VERIFY if using correct PATS key, if defective USE new key. B1342 ECU is Defective (EEFROM in PCM not working) PCM INSTALL a new PCM. REFER to Section 303-14 . B2103 Antenna Not ...
...keys. If the N_KEYCODE PID reads 0 or 1, and the MASTERKEY PID reads NOTPREST, that particular key must be programmed into the IC. If the N_KEYCODE PID reads 1, and the MASTERKEY PID reads PRESNT, ...
...program have the correct mechanical cut. NOTE: Performing this procedure does not erase existing programmed keys. Insert the programmed key in the ignition. Turn to RUN. THEFT indicator proves out ...
...program new keys again or have the body control module rebuilt or replaced? Please help I don't care if the jeep has anti-theft or not I just want my jeep to run. Thank-you for any help you ...
...program and allow vehicle to start. Again cycle first programmed key to run position. Within 15 seconds, remove original key and turn new unprogrammed key to run position. The theft indicator should ...
...original compute installed the truck runs on 7 cylinders and has that P0353 code. thanks in advance You need to run the pcm replaced routine through a scan tool. If the vehicle has any kind of anti ...
...original back and it started. is the a way to fix this or wat. No can do. Requires a trip to the dealer to have the new cluster programmed for your truck, which would bypass the odometer fraud you ...
...original vin# to remove the old one? This sounds like you didnt. Get a programmer to check it out for you. They are linked with the ignition, some keys and obviously the ECM. If you did not have the ...
Question about Dodge Ram 1500
original keys , you will need someone to remove the original keys from the pcm , than marry the 2 new keys to the pcm. If you have an original key , try placing it by the lock cylinder when attempting
1,093 questions posted
Usually answered in minutes!
264 Questions
1,788 Questions
1,318 Questions
1,048 Questions
677 Questions