...Intake plenum, lower intake manifold and exhaust manifold Valve and timing chain covers Coolant connections for the cylinder heads Rotate the crankshaft until the crankshaft timing mark aligns with ...
...Intake Plenum Gasket R+R Torque Sequence Just need torque sequence/settings for upper intake plenum gasket R+R? I cannot post a picture here because that is copyrighted material. However, the ...
Question about Dodge Intrepid
...plenum intake please. check out the video and also click the Image tab for sequence. ...
...intake plenum of a 2007 Chrysler TWC. Here are the steps: Remove covering on lower intake manifold and clean surfaces. Inspect manifold gasket condition. Gaskets can be re-used, if not damaged. ...
6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs (To torque bolts, start in center using crisscross pattern
Question about Dodge Intrepid
...intake plenum on a 2007 Mitsubishi Endeavor 3.8l I replaced both cylinder heads and was able to get information on all the torque specs and sequence for everything but that. I tried the old work from ...
...intake plenum and gasket Thermostat housing Electrical connector from the Engine Coolant Temperature (ECT) sensor Drive belt tensioner assembly EGR valve outlet pipe Lower intake manifold Fig. ...
...intake plenum Her's a web link for you to see the torque and sequence depending on the engine size, 2.0 or 2.5 from 2007 to ...
Question about Dodge Intrepid
torque specs on intake plenum and fuel rail on a 98 ford Ranger with a 4.0l Hi the torque spec for this fuel rail/manifold is 9-11lb/ft. Here is pic of the sequence.
Need torque sequence and torque specs for intake plenum on 3.5L 02 Olds Intrigue. bottom intake bolts torque 15-18 ft lbs from center and in criss cross pattern top plenum bolts 12-14 ft lbs
1,377 questions posted
Usually answered in minutes!
1,166 Questions
867 Questions
766 Questions
627 Questions
548 Questions