2006 Ford Taurus "car idle rough o2 sensor" Questions

rough in park up to about 2000 rpm's and then seems to get better. In drive or reverse I can only get up to about 1100 rpm's at full throttle. I have already changed the mass air sensor, plugs, wires,

...rough or stalls during an idle. The transmission is an automatic; I have to shift to neutral in idle and put back in drive after giving the gas to to keep from stalling when coming to idle. My ...

...idle, engine is vibrating so much that the whole car shakes when not accelerating and when it is put in gear it shifts noticebly. There is now smoke coming out of the exhaust. Today it has been hard ...

...rough.Has Code P2197Lean bank 2.4and6 Misfire at idle goes away at acceleration. We renewed upper and lower intake manifold gaskets and all kinds of hoses. Replaced the 02 sensor as well. With the ...

...rough idle. what could be wrong The check engine light is because all check engine light codes are caused by components that affect emissions. It's not actually an engine problem, it's a ...

...start flashing the engine come on then it will start flashing i have a rough idle. what could be wrong maybe the problem on your O2 sensor, MAF sensor, fuel/air ratio, pyrometer or exhaust.hid kit ...

2006 ford taurus idling roughly. Replaced idle control valve but car still idling rough MAF (mass air flow)sensor or o2 sensor and exhaust MAF can be cleaned many sites tell you how too

...rough, but seems to have no problem in accelleration. Fuel pump doesnt stop after five or seconds, like normal. seems like engine is takin in to much fuel really rich Run a code scan. probably an o2 ...

...patched the intake and then we replaced the catolitic converter. iran fine for a short while now i am getting o2 sensor stuck lean bank 1 and 2. and it is idleing rough I bet the patch blew ...

rough idle-cutting out at higher speed The check engine light came on flashing. I disconnected the battery & reconnected it. The check engine light stays off but it has rough idle and was cutting ...