1995 Dodge Ram 2500 "crank sensor van" Questions

Ad

...crank sensor 95 ram van 3.9 how to check crank sensor on 3.9 95 dodge van you will need a volt meter and know the voltage of the crank sensor so you will know if the voltage is good when you read it ...

Ad

Question about Dodge Ram 2500

1 Answer

...van no start Code P1391 Loss of crank or cam sensors,P0340 No cam signal at the pcm. I would replace the crank sensor first. Your cam sensor is part of the dist. on 5.2/5.9 engines. Hope that

Ad

Question about Dodge Ram 2500

1 Answer

...van no ignition This problem occured on the highway. the engine just stopped. After I got it home I discovered there was no ignition. Further test revealed that there was no voltage at the coil. ...

Question about Dodge Ram 2500

1 Answer

...crank sensor the cam shaft sensor the plugs wires cap n rotore installed it was fine then after driving high speeds exiting the ram to slower traffice the car had a hick up and now i have a miss fire ...

position sensor location 2001 dodge 3500 van cam or crank position sensor location with the 5.9l 360 v8 motor. Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor

...crank sensor on 5.7 gmc 2500 cargo van can't fine crank sensor on 5.7 gmc 2500 cargo van What year is it Mike? its in the timing cover at the front bottom of the engine near the crank ...

...crank position sensor on a 1997 astro Hi guil,Can you tell me how to test the crank position sensor on a 1997 astro van ?The sensor is not installed on the van and I do not have access to the van ...

crank shaft sensor. Van drove fine, has a slight stutter. 3 days after replacing the crank shaft sensor the van stutters and dies within 10 seconds of starting. any ideas? maybe have autozone or equal

...crank sensor. As long as the van is sitting still and just running it doesn't cut of . just when you are driving it cuts off. sometimes it will crank right back up and go sometimes it will crank back ...

...THE HARMONIC BALANCER HAVE DAMAGED THE CRANK SHAFT POSITION SENSOR. CAUSING IT TO NOT START. it could be your problem for sure ....the senor or wires cut have crank sensor adjust if not change ...

Not finding what you are looking for?
Cars & Trucks Logo

334 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...