1994 Dodge Ram "engine harness connectors" Questions

Ad

Question about Dodge Ram

1 Answer

...harness connector. In the engine compartment, remove the heater/air conditioning housing assembly-to-chassis nuts. In the passenger-s compartment, remove the heater/air conditioning housing-to-dash ...

Ad

engine controller harness connected for this test. NOTEIf voltage is not found at the PCM connector, you will need to diagnose the system using a DRBII scan tool, or equivalent, or take the vehicle to

Ad

...harness It is hard to get to - the sensor is at the back of the engine mounted through the transmission bell housing. The connector should be within 6 to 8 inches from the sensor. The sensor reads a ...

Question about Dodge Ram

1 Answer

...engine compartment. The bay is a fairly large black plastic box on the driver's side. Open it and disconnect the largest connector inside (one screw). Spray electrical contact cleaner on the pins and ...

engine off stand out of the way of airbag and wiggle the electrical connector and see if u can duplicate problem also check 4 chaffed wiring Actually under the steering column there is a wire harness,

Question about Dodge Ram

2 Answers

...Engine hesitation Possible causes - Harness or connectors (EGR volume control valve circuit is open or shorted.) - EGR volume control solenoid valve - EGR temperature sensor and circuit Possible ...

...connected to coil about 1/2 inch from ground turn key on take a jumper wire and jump the wires on the engine harness side of the connector if it has a spark replace the pick up coil in the ...

Question about Dodge Ram

1 Answer

Engine swap, I have a 97 1500 2wd V6, I am putting in a 98 318, I need to know where I can get wiring color codes because none of the wiring matches up from the two trucks. If I use the 98 PCM, can I ...

Question about Dodge Ram

1 Answer

...Engine light also comes on and occasionally when tach is acting up the truck won't start. usually releasing fuel from the fuel filter allows it to start. Any help would greatly be appreciated. yuck ...

Question about Dodge Ram

2 Answers

...engine, there's a connector where the crank position sensor plugs into the harness. I yank on the cable a bit, and it then it will start, lasts for a couple weeks or so. I'm guessing there's a worn ...

Not finding what you are looking for?
1994 Dodge Ram Logo

287 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Ram
1999 Dodge Ram

1,788 Questions

2004 Dodge Ram
2004 Dodge Ram

173 Questions

1998 Dodge Ram
1998 Dodge Ram

143 Questions

1990 Dodge Ram
1990 Dodge Ram

114 Questions

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...