1999 Dodge Ram "change oil sending unit 99" Questions

oil change. I took it back oil can henry's. And they said according to the test light it showed low oil pressure. So they changed the oil filter again and toped it off and sent me on my way. Saying it

...change the oil sending unit 99 deville northstar? leaking oil leaking oil...lots from the frount side on the motor...oil sending unit? where is it located? oil sending unit on the 4.6L engine located ...

...change u just need a special tool for removed on front of motor at right of oil filter its look like a coolant sensor or a little bottle with a connetor removed the connector and take the tool to ...

you said you changed the oil sending unit, and tried a aftermarket which worked, so the other option is to have you oil gauge checked. The sending unit may be good but you gauge is not reading proper

My 99 Jeep grand cherokee is staying on 80 for the oil pressure. I went and had my oil changed and still the same. What do you think the problem is? your oil sending unit is bad, cheap fix!

...oil pump, sending unit could be pluged but that would give you excessive oil pressure IT IS A N OIL PRESSURE SENSOR THAT IS ON THE BACK OF THE BLOCK W/A WIRE OFF OF IT TO DASH YOUR VEHICLE WILL NOT ...

where is the oil pressure sending unit located on a 99 tahoe How hard is it to change? at rear of engine, you need a special socket to remove it and it is very hard to get at.

...oil will help dissolve any carbon or sludge and help with that. Also check the connection at the sender. Can also be the sender itself going bad. Pressure will normally rise and fall with engine rpm ...

oil change done sometimes the gasket from the old oil filter sticks to the block. when you install the new oil filter it ends up with 2 gaskets and leaks around the base where filter meets oil cooler.

...change my oil pressure unit If it is like my 4.6 northstar in 99 deville, it's not easy. From under car look up beside oil filter and you can see to unit. Remove filter for better access, but still ...