2001 Dodge Ram 1500 Truck 2WD "evap service port hose" Questions

service bulletin. P0300 is a combined result of the two misfires. P0442 is a medium evap leak (p0456 is a small leak) which should be easy to find. What I would do first if the engine is running fine,

evap service port should there be black dirt or sand in the evap service port hose no it should be clean. there should be a green cap on top.

...VALVE WITH A HOSE ON EACH END WITH A SMALL VACUUM HOSE ON TOP..IT SHOULD HOLD VACUUM WITH HAND HELD VACUUM PUMP..HAVE ALSO SEEN SPLIT HOSES NEAR EVAP SERVICE PORT LOCATED NEXT TO AIR CLEANER ...

EVAP service port (8). Remove the electrical connector (6) at the EVAP canister purge solenoid. Remove the EVAP canister purge (2) solenoid valve bolt. Remove the EVAP canister purge solenoid tab from

EVAP Service Port leaking. Fuel vapor lines or purge lines damaged or leaking .FTP sensor is out-of-calibration, damaged or "skewed" .PCM has failed .TSB 61-65-31A contains a repair procedure for this

...EVAP) System for the following conditions: ?€¢ A loose, missing, or damaged service port schrader valve ?€¢ A loose, incorrect, missing, or damaged fuel fill cap ?€¢ A damaged EVAP canister purge ...

...EVAP Service Port The EVAP service port is located in the EVAP purge pipe between the EVAP purge solenoid and the EVAP canister. The service port is identified by a green colored cap. EVAP Vent ...

service engine soon light from staying on? Continuous Memory Diagnostic Trouble Code (DTC) P0442 indicates that a fuel vapor leak has been detected [as small as 0.10 cm (0.04 inch)] in the Evaporative

...EVAP system. EGR valve? is bolt on,.yes vac,no hoses. the service manual covers this. is this a post collision question or bought truck with no engine question, be nice to know how bad this is. (the ...

...SERVICE PORT DO NOT USE UNREGULATED PRESSURE ABOVE 6.89 kPa (1 PSI)] near EVAP canister purge valve or EVAP canister. If vehicle is not equipped with the evaporative test port, GO to HX50 . Install ...