1998 Ford Expedition "drive shaft" Questions

drive shaft but it's drive like it's in 4wd. The button is set for awd is there anything that can be done with it until I can find a drive shaft? Unfortunately No, the System was designed for the Rear

...drive shaft came off need to fix how? The answer to this depends on exactly what happened. Typically a universal joint fails and drivers fail to get it repaired. This situation is a ROLL OVER danger, ...

...drive line shaft (tail shaft) check the u-joints for a rust streak around the cross and cups. They u- joint goes dry and will squeak as the joint goes through the angle of drive. If you have a front ...

drive shaft, could that cause it from not wanting to go into overdrive? It acts like it's missing when it tries. IF you are saying that the rear drive shaft is missing then you should have it replaced

...drive shaft broke on my99 expedition 5.4 with4x4 so I replaced it then my rear end started lockin up so I replaced it now my reear wheels roll then lock up,roll then lock up, any ideas? u need to ...

...drive shaft and remove the tail stock seal(there are install and removal tools but a hammer and a screwdriver will remove it nicely)then replace with new seal (if you don't have the install tool a 5" ...

if your drive shaft is making clunking noise do you have to change the whole drive shaft no, universl joints are all that need to be replaced

...drive shaft out of balance ujoints are worn *steering bars are worn or need tytening curb checking your rims this can lead to unbalance *one or more of your tires have lost there balancing bars that ...

...drive shaft while you give enough gas to make the tires spin, if the front drive shaft spins and the front tires don't you have a bad hub if it does not your transfer case is not engaging which is ...

...shaft underneath As soon as start to drive I feel some hesitation and a noise as if something is stuck somewhere. I think it comes from a U Joint between the two shafts underneath. Anyone with any ...