...PCM is located behind the engine on the passenger side of the car, the nose of the PCM sticks through into the engine comapartment behind the cowl cover. To remove it follow these instructions: ...
...only AC vents are there. The PCM connector is on the firewall - but getting to the module itself is a mystery. ... anyone know how? It's located behing the lower kick panel on the passenger
...PCM is located behind the engine on the passenger side of the car, it is in a slot in the fire wall behind the cowl cover. here is Fords instructions for replacing it.Powertrain Control Module (PCM) ...
...left-hand exhaust camshaft sprocket. The CMP sends a signal relating camshaft position back to the PCM which is used by the PCM to control engine timing. The camshaft position sensor (CMP) on the ...
I need to replace PCM (Powertrain Control Module) ... but can't find it. The car is 2004 Taurus SES with DOHC. On-line there is described (for 2004 Taurus) location behind glovebox - but only AC ...
Question about Ford Taurus
located on 4 Ford Taurus 3.8 engine a how do I replace it Hi Tracie , there is no ignition control module . The PCM controls the coils . You would need to check the red wire going to the coil pack for
...located back of the engine compartment on passenger side: Removal & Installation 3.0L (VIN S) Engine Before servicing the vehicle, refer to the Precautions section. Park the wiper pivot arms in ...
...PCM .... but the symptoms are the same.... Including the buzzing.... All ground connections (firewall and under driver seat) seem good. Purchased code reader but there are no codes. At a total loss ...
...RH water shield screws and remove the RH water shield. Disconnect the powertrain control module (PCM) electrical connector and remove the gasket. Remove the retaining bolts and the PCM. To
1,980 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,120 Questions
1,869 Questions
1,365 Questions