Question about Ford Taurus
...Remove the fuse related to the throttle body (leave it out for about 10 minutes). Reinsert the fuse. The throttle body sensor should reset. Driving the Vehicle: Drive the car on the highway at speeds ...
...throttle position sensor,rebuilt distributor shaft,new cap and rotor,new plugs and wires,spout circut pin,ignition control modual,computer, I am told that the crank sensor in built into the ...
...remove the subframe bolts. Fig. Throttle and cruise control cables-2001-04 3.0L (VIN U) engine shown Fig. Throttle Position (TP) sensor and Intake Air Control (IAC) valve connectors-2001-04 3.0L (VIN ...
Question about Ford Taurus
...throttle body and checked for air/vacuum leaks, no good. Noticed that when I remove electrical connector from idle air valve all ok but check engine lite comes on. chech engine light is letting you ...
...throttle assembly towards the back and top of the engine and remove the shield. Pull the retaining pins using a pair of slip joint pliers if necessary 3. Remove any other accessories that might ...
...remove the Throttle Body cover, get a can of carb cleaner and spray the heck out of the TB do this while running throttleing it, dont let it idle, it will die out on you. Keep in mind that the ...
...throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local ...
...Remove the throttle sensor by pulling it in the axial direction of the throttle shaft. Remove the throttle sensor O-ring and discard. To install: Using a new throttle O-ring, install the throttle ...
...throttle valve opening based on the TPS output voltage. Removal & Installation Disconnect the negative battery cable. Disconnect the sensor connector. Remove the sensor retaining screws. Remove ...
Question about Cadillac Cars & Trucks
Throttle Position Sensor Replacement Removal Procedure Remove the idle air control (IAC) electrical connector (1) from the IAC sensor (4). Remove the manifold absolute pressure (MAP) sensor electrical
2,993 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,121 Questions
1,431 Questions
1,365 Questions