...know about it. to replace the pump you must remove the tank. you can do it by yourself if you have jack stand and a good floor jack. put the rear axle of your vehicle on the jack stands equally then ...
...up lamp and, if equipped, neutral sensing switch harness connector. Place a wood block on a service jack and position the jack under the engine oil pan. On 4WD vehicles, remove the transfer case from ...
...wire going to it. I would also replace it through the wheel well if I were you. You'll have to jack and take the tire off. Hope this helps. God ...
how do I replace a starter on a 1997 ford ranger? disconnect the negative battery terminal. jack the front end up and locate your starter. disconnect the wires that are attached to ...
...it is to go through the drivers side wheel well by lifting the rubber flap up. You'll have to jack and take the tire off. Hope this helps. God ...
...on a Ford Ranger will take about 20 or 30 minutes. Raise your truck 6 inches off the ground with a jack. You can drive the truck on ramps if you have them. Lifting the truck will make it easier to ...
a multi meter you can read the voltage of each wheel sensor at the other end of its wiring harness. Jack up the front end and find the end of each wheel sensor harness and spin the wheels by hand. you
where is jack locations I assume you are asking where it is safe to jack the vehicle with the factory provided jack. These locations are in front of both rear wheels there are jacking points you can ...
where's my jack supposed to be? I've owned my car for about 5 years. I hadn't had a flat tire until last weekend. I could not locate the jack or even where the jack is supposed to be. Can you please ...
location of wheel jack Where is the jack located? Lift up the table or cover on spare tire and the plastic housing for the spare tire then lifts up (by removing some simple pins) and the jack is ...
671 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions