1989 Ford Ranger "paper orientation" Questions

...orientation as old one came out and place gasket on thermostat housing      (pay attention some gaskets have paper covering self adhesive). Place bolts through housing and ...

paper clip. Jump pins A to B at the 12 pin diagnostic connector. (Top right pair wires in the connector - or - Lower left pair of wires depending on orientation) Turn key on. Count the "blinks" of the

heater and AC work on 2001 chevy silverado 2500HD, but no fan I've read in several forum posts that this may be the result of a faulty fan switch (one of three in the bank along with hot/cold dial and

the old gasket that was pressed between the intake manifoldand the thermostat housing cover. It's a paper gasket and should pull off ofthe intake in one piece. Remove the thermostat from inside of the

...and never didn't find it. The 2000 Intrigue doesn't take a typical oil filter. Its actually just a paper oil filter element (minus the metal case) that you buy in the store. Cost is about double of

...gasket that was pressed between the intake manifold and the thermostat housing cover. It's a paper gasket and should pull off of the intake in one piece. Remove the thermostat from inside of ...

...actuator pin on top of the spring. If you don't see the tip, get something like a small nail or a paper clip, flip the outer tube over (do this over a piece of white paper or similar) and if the

orientation of this connector could be mounted upside down. Proceed only once you have identified pins 1-8.2. Using a suitable jumper wire (a paper clip or thin car speaker wire will suffice), connect

paper fuel rail gasket is starting to or maybe already has broken between the intake ports. This will cause a lean code condition. (P0171 and P0174) 2. Gently pry the fuel rail off of the lower intake

leaking from conection at gasket and thermastat I put a new thermastat in and replaced the old paper gasket, put the sealer on. Put back the 3 bolts and I still have antifreez leaking . What am I ...