1998 Ford Ranger SuperCab "98 takes time" Questions

...98' Splash Supercab with automatic transmission don't shift 3rd and overdrive gear, and the o/d light start to flashing. you will need to connect it ti a scanner to confirm but it sounds like your ...

98 ford ranger, cranks, but does not start sometimes cranks strong, randomly does not start, went 5 days without starting, bring it to a shop, starts every time. i am wondering if it is the fuel pump,

98 ranger 4,0 very hard to crank when it does it runs very rough for a couple of min then levels out but does not have the power it should I'm not sure what you mean by being hard to crank. If you ...

98 ford ranger xl. They rub the rotors when the truck is driven. We didn't see any springs or anything that would hold them off the rotors. Are we missing parts? 1998?? if their is excessive drag then

...98 Ranger. Will start and idle but that's it. getting P0102 code. that code is for the mass air flow sensor. That sensor takes the temperature of the air going into the engine and sends it to the ...

I need to replace a Front wheel bearing on my 98 ford ranger. Remove the wheel and take off your brake caliper. Once you have the wheel off, you will see a dust cap in the center of the wheel. Remove ...

...solenoid see what it dose .Of corse check the battery and all connections first make sure this test is valaid . Its an 98 it could be time for a new starter the good news its easy and inexpensive to ...

...98 Ranger.(code 27) My light on the module that turns off the passenger side airbag was burnt out. I went to Radio Shack and bought a 12v light with wires attached and soldered them to the existing ...

cost to repair timing on 98 silverado Thinking of trading for 98 silverado and need to know what it will cost to get the timing fixed. If you are talking about the timing chain 400 to 500. Depends who

...time and money to convert the 89 4.3 to work on the 98 blazer, it would be cheaper to install a 98 vortec rebuild. The 89 4.3 have a TBI fuel injection system and the ecm on the 98 will not work and ...