1991 Ford Ranger Supercab "reset idle focus" Questions

...idle reset proceedure as described in owners manual. seems a little better but is idleing very low.it almost seems normal if you turn on the air conditioner.would it help to replace the fuel ...

...if perished and split the engine will not idle .You cannot adjust anything without a dealer software to reset the mapping so check these pipes first and iam sure you will find their split and gone ...

...idle is too high. Replaced the timing belt set TDC and Cam as per Haynes manual. Started engine idles at 2200prm if step on gas goes up to 3000 slowly comes back to 2200. Diagnostic unit shows no ...

...idle. Depressing the clutch, turning the car off, and then back on will reset the rpm back to normal operation. Check for stuck throttle plate. Check pcv hose that goes to the intake manifold. They ...

idle to 2003 Ford Focus after battery reset? i replaced the plugs after it began to idle rough at stops, the parts shop gave wrong type plugs. i got right ones and installed hurriedly thinking the gap

...light was on, then when I got the idle reset it went off, then it came right back on and it dies only when I am using heat or air. Do you know what the code was for the check engine light being

...Reset idle down to normal. Now it guts out at 20KM/hr still idles. The RPM are off the roof in Park and Neutral. THe TB was cleaned, I am at a loss. What is wrong with it, What more can I do? i had ...

idle control valve helped alot. was dieing alot more earlier. but still every so often...never got a engine warning until now- auto parts tested it says oxygen sensor upstream, they reset the conputer

...focus check engine light started blinking when I was on the freeway. It stopped blinking, but now it sputters and chokes at idle and during acceleration. It had a full tune-up about 10 days ago. Any ...

...reset the light and worked fine for a week but came back on yesterday, spoke to another garage and they said the same, but the light went back off this morning. Do i need to replace this distributer ...