2001 Dodge Intrepid "coil problems spark" Questions

...spark. Each coil pack that sparks on #2 will not spark on any other connector. Spark from #2 coil is weak. I then replaced the wire harness from the PCM to the coils and fuel injectors and still only ...

...coil for spark for each cylinder. If none: Don't replace it yet. 4. Test each spark plug and wires this way. 5. Coil Packs normally provide fire for 2-cylinders at the same time. The two are paired ...

no spark, next is to see if the coil controls are working -the Ignition Control Module (ICM) is that controller, and it gets a signal from the engine computer, for when to control the coils for spark.

...SPARK when coil is connected?have you tested with a spark tester tool not spark plug not efficient!!! also have you tested all the in car fuses and under hood fuses with circuit tester tool not ...

...coil too In cars with no distributor you normally have one or more bobbins also called coils. Check if you get spark in some spark plugs or if you get no sparks at all. Some cars tend to get this ...

...problems 1 out of 5 starts quiting and starting again while driving I have replaced ec unit fuel pump, kill relay, Check the connector to the coil pack/module. For wire connector on my 3.3L coil pack ...

...is getting a spark. If push comes to shove, take it to a repair shop and have them diagnose the problem. I would start at the coil/coil packs and go from there. Could have bad coil pack or ...

...spark from my coil, is it on the bottom of my distributor? because i pulled that one to check for spark and it shut all dash board lights off completley. couldnt turn car over from there. Check the ...

...spark at any of them ,that coil could be bad (Most Likley), If all Have NO SPARK then it is One of the fallowing,, Cam Sensor Crank Sensor Ignition control module If Control module is wet with Oil ...

...spark in none of the coil ignition in dodge 2.7 intrepid 2004 No spark in none of the ignition coil. camshaft and crankshaft was checked and are good. What could be the problem? check for the main ...