...know how it works out please Hello ju2454. Fuses are in place to protect the circuit from overheating the wires. So if there is too much current flow the fuse burns to open the circuit. So there is ...
...know what other things I can look for? Hello! If you have a volt meter, check the following points for +12 volts...At the wiper motor assembly connector...Check Pin A Purple wire...Pin B Dark/Green.. ...
...12 volt light bulb can verify/eliminate this as the cause. Connect a bulb (12 volt) to the connector contacts which plug into the horn. Then activate the horn (press on the steering wheel airbag) to ...
Question about Ford Windstar
...the black wire to any ground and the tip on the connector have someone to crank it up if it lights, is good if not is a bad ignition. Don't know how to do it get an electromechanic. Hope this ...
...wire will be black or brown. You might want to just check both wires. If voltage is present the pump motor is bad and will need to be replaced. If there is no voltage you have an open circuit between ...
...know how many volts should be travelling through the 4wd wires On the full size, the front actuator is electric, not vacuum. When in 4wd mode, a switch on top of the transfer case conducts 12 volts ...
Question about Ford Cars & Trucks
...feed. I don't know if you have a gage fuse in your fuse box? I won't have a wiring diagram for this model year. One of those wires is voltage, I don't know if 12 volts? You can check it and see? If ...
...wire on relay the fans come on, is there a temp sensor that controls fans. I thought it was controled by computer. I know there is a sensor next to thermostat housing but I thought that was for the ...
...know the bulb is good cause I put it in the right side and it works on dim and bright.on the bulb that does not work on dim(driver side) I am getting 8.6 volts on low beam ,but not the full 12v. does ...
wire to the positive or battery side of the coil and see if it starts if it does it can be two things. One the resistor Or the ignition switch, They had both One when you crank it over it fed 12 volts
2,613 questions posted
Usually answered in minutes!
1,838 Questions
1,503 Questions
1,212 Questions
1,032 Questions
600 Questions