one coil wont fire 1994 ford ranger 2.3 liter 1994 ford ranger 2.3 liter has 2 coil packs and 8 plugs the intake coil wont fire and have replaced it and plugs and wires crank sensor or cam sensor ...
changed the crankshaft sensor an still no fire its not getting any fire so i changed the crankshaft sensor an still no fire Did you check to see if you are getting voltage to the coil ?I would check ...
Question about Ford Ranger
...FIRING ORDER.
ON TOP OF COIL CLEAR AS DAY 6" SEE 3 AND 4 THERE, THEY FIRE AT THE SAME TIME.
AS DOES 2/6 AND 1/5
5: CYLINDER #1 ON ALL V ENGINE IS THE ONE MOST FRONT
IT IS OFF SET TO ...
my 3.0 ranger cranks but will not start is not getting fire to plugs changed coil pack cps crank senser what else could it be Sounds to me like a bad control module. The control module controls the ...
...firing we have replaced the coil and also the control modual but still no fire where else should i look did you guys put a meter on the wires going into the coil and make sure they are getting power ...
...coil 1 & 4 were firing while 2 & 3 weren't. On the back coil 2, 3, & 4 weren't firing. When it was running ok, all 4 were firing on the front coil, but on the back coil 3 & 4 still ...
# cylinder 3 misfire #3cyl miss fire plug and wire check to be good changed coil pack stii miss fires. what could the problem be ? you don`t say how you verified that the plug and wire was good. I ...
89 ranger 4 cyl 8 plugs 4 have fire and four dont is this bad coil it has two coil packs it is eaither that or the firing diode in the fireig plate causeing it.
firing order for changing sprk plug wirers to coil.. changed wiring and 1st startin truck hesitates then cranks. real rough shakin then starts its like it has a mis This is the firing diagram. I'm not
927 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
558 Questions
477 Questions