2005 Ford Taurus "reset idle control valve" Questions

...has idled at 500 rpm since then. Replace the idle valve with a factory one and remove the negative battery negative cable for 5 minutes to reset the idle control system to base line

...TAKE VECHICLE TO FORD DEALERSHIP LET THEM RELEARN THE IDLE AIR CONTROL VALVE TO THE PCM. ITS GOING TO COST $35.00 TO RESET.BUT CAR NOT GOING TO IDLE CORRECT UNTIL NEW PART REPROGRAM TO THE ...

...and reset "idle learn" system to base line in the Power Train Control Processor. Drive a few days to reset idle learn and this should cure the issue of stall, if not you may have another part

Car idle goes up and down Take the idle air control valve off the throttle body and clean carbon out of it using a non chlorinated brake cleaner then reinstall and reset computer.

idle control valve, ignition control coils, had an engine flush done and i'm still getting this code. what's wrong? Code 300 is usually for multiple misfire. IF you DID NOT get the computer reset/code

...Idle Air Control) valve fault, or it could just be that the idle speed requires adjustment. Have you had a flat battery or a battery replacement recently? This can cause the computer to loose its ...

idle air control on my 2004 Ford Taurus, and when I started the car, the engine is racing to almost 3000 RPM's what can I do? I unhooked the battery to see if the computer would reset, but nothing

idle air control valve is stuck open just a little to much which would cause the computer to feed the engine more fuel and cause this high rpm problem.Take it off and try cleaning the carbon out of it

...Idle Control needs to be replaced? Last tune up was at 65K. Gary If there is no check engine light on I would go the local auto parts store and check out the TP sensore first and then the Mass air ...

...reset computer & it will relearn idle strategy after about 5 minuets of driving. I would be checking my Idle control valve,I suspect its stuck and when it warms up it works,I hope this helps you, ...