2002 Oldsmobile Alero "turn key position 2 disconnect" Questions

I disconnect the battery and leave it for a 1/2 hour, thenreconnect and turn the key to the acc position for 10 minutes it will start. What could be causing this. Give some more details of the problem

...THE MOUNTING BRACKET THEN LIFT OUT.TO REMOVE LOCK CYLINDER PUT KEY IN SWITCH TURN TO RUN POSITION THEN DEPRESS THE PIN WITHDRAW THE LOCK CYLINDER. how do i replace ignition switch 1998 olds

...Turn the key on, the voltmeter should read 12 volts, if not check the wiring to the PCM. If the circuits are good, have the PCM checked out by a Dealer or other properly trained shop. To check the ...

...key (modification switch must be in the OFF position). Turn modification switch to the ON position (contacts open). The SECURITY or THEFT telltale will light up indicating that the Passlock System is ...

...Turn key to on position 4.Connect battery 5.Wait one minute 6. Start the car and hope for the best. Good luck **Ps make sure your gas tank is topped off i did this after reading numerous post This ...

...key in ignition & turn to "On" position, apply brake, and shift into "drive" or lower gear. Turn HeaterAC module to the left, sideways orientation, and pull out the Radio. Disconnect main wiring ...

...Key on, engine off - push the reset button 2-3 times slowly. The oil change light will start flashing. Hit the reset again. The tire pressure will start flashing. Push and hold the reset until the it ...

...the key off and reconnect the negative cable, turn the key to run position and listen for the fuel pump to come on 2-3 seconds try to start..repeat this 2-3 times if still an issue.. repost ...

...key to the on position? the manuals says Rotate the lock cylinder key to the Lock position. Disconnect the negative battery cable from the battery. For tilt column only, remove the upper extension ...

...turn the key to the Off position to free the cylinder. Once it is free, turn the key to lock position and remove the key and key cylinder. 6 Install your old key cylinder into the new ignition switch ...