Question about Isuzu Rodeo
...cover. Rotate the crankshaft to position the timing marks at Top Dead Center (TDC) of the No. 1 cylinder's compression stroke. Remove the timing belt tensioner adjusting bolt and the tensioner from ...
...v6 Remove belt, fan, fan shroud and fan bracket. Remove timing covers, timing belt and water pump. Replace timing belt and the hydraulic tensioner with new ones. I suggest you get a mechanic to do ...
...if it is a 3.2 v6 it is internal you have to remove the timing belt cover on the front of the engine the water pump is driven by the timing belt it would be wise to replace timing belt at the same ...
cover to manifold 7. Attach coolant hose 8. attach lower coolant hose 9. Fill with antifreez, until almost full 10. Start up motor, (should never start motor with coolant system empty) Last we want to
How to remove serpentine belt tensioner assembly on v6 3.2 lt DOHC (6vd1) engine so i can then access timing belt covers etc..????? I have the assembly loose to the point that it rotates about 90-100 ...
...Removal 1. Disconnect battery ground cable. 2. Disconnect connector of intake air temperature sensor from intake air duct. 3. Remove PCV hose from air intake duct. 4. Remove nut from air intake duct ...
...V6 SOHC engine. It has 57,000 miles on it so I am changing the timing belt. The manual (Haynes) that I have says and shows the alignment of the timing marks on the sprockets, belt etc. It says that ...
...cover and intake lines up with mak on exhaust pulley but cannot find mark to line up nick in bottom pulley. Click on the following direct, Free Link. It has Diagrams and Instructions including the ...
...isuzu V6 located on right side of engine looking from front, behind right timing belt cover? WATER PUMP HAS THE FAN ASSEMBLY ATTACHED TO IT AND YOU HAVE TO REMOVE TIMING COVER TO REMOVE WATER
550 questions posted
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions
