happy thanksgiving, u gotta remove the negative battery post. Remove bottom panel under steering wheel 4 screws, 1 electric connector. Remove the trim around the dash 4 screws 5 connectors. Remove the
...turn signal/cruise lever and cancel cam. 4) Remove tilt pins with a pin puller(about $10) 5) Tighten the four loose screws that hold tilt mechanism to the column. Be happy you do not have
...wheels center nut(approx. 3/4 " hex nut) that locks the wheel onto a splined shaft. Remove the 3/4 nut and mark the spline shaft to the steering wheel with a light tap of a punch just to identify how ...
...bearings inside and when the housing wears out, they make that clunking noise. See your mechanic for a change and see if you can replace both wheels at the same time. Hope that helps. Happy motoring. ...
...4 wheel drive and that is the fuse in the number 17 position. That is for the transfer case shift motor (see picture of fuse layout below) Now there are 2 relays for the "shift on the fly". thoses ...
...the lines (red and green) going to it and then the actuator it's self. It's only held in with 4 bolts. If I've helped, please rate my assistance, and leave a testimonial. Thanks and Happy
...4 wheel drive no longer worked. Vacuum hose??? WJ jeeps. what mode? 4h, 2l lock >? why not just drive it and get it all loose and happy first. get the gearlube hot, see if it wakes up, i bet it ...
Question about Isuzu Rodeo
...4 Also You Can Try Autozone Or Kraigen But They Never Have The Ones I Need. Its Also Very Easy To Do Yourself If You Can Change The Brakes You Can Do This. You Can Have Them Pressed In At Any Tire ...
4- If it still wont come off spray again with penetrating fluid and leave to sellte for a while and try again. Make sure the rotors are not held on by the wheel bearings, some models require the wheel
785 questions posted
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions