1997 Jeep wrangler rear emergency brake cable replaced and now brake light stays on possible cable out of adjustment to loose.try forcing brake aplicator towards full off and see if it goes off. if so
light,as looking at fuses you can`t always see if its any good.if they are good then you will have to check the wiring for a brake in the system start at the rear of the car,and work towards the front
...wiring. If the brake and turn signal are on different bulbs than you'll need a wiring harness with a converter box. I'm pretty sure the wrangler has the brake and turn signal on the Same bulb ...
wiring harness for continuity between the brake light switch and the brake light sockets. I had an old bronco II, Ford was nice enough to run the wiring harness on the bottom of the floor pan exposing
brake fuse not the tail park lights. got trailer wiring hacks on car/ (look) there are 2 lamps, lamps short. put in one new lamp, does it work? y/n if no , and the new brake lamp switch as 12v on both
...wiring must be repaired or rebuilt. Regards. When the brake lights don't work and the lights are out of the dash it is caused by a shorted light bulb, the brake light and turn signal are on the same ...
I have a 2000 Jeep Wrangler Trouble Symptoms: -When lights are on, brake lights (all three) remain illuminated and only flicker when brake pedal is depressed. Facts: -With lights off, dashboard lights
need the color of brake light wire at rear of jeep the brake light wire on ALL cars trucks & s u v 's is the same. green & yellow are allways R&L turn & BRAKE
when pressing the brake pedal non if my 3 brake when pressing the brake pedal none if my 3 brake lights work i changed the brake switch i checked the bulbs and they are good when i turn un my lights ...
491 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions