...3.5l fuel injector removal instructions no job stated, just 1 injector,? pull? which bank or both, matters........ same as all fuel rail injectors.really....cept access. 1: do the fuel depressurize ...
...3 marks, 2 lines and one mark that is actually a row of dots. Align the dots to the crank pulley groove mark(2) and align the other 2 lines to the cam pulley marks. Using a clothes peg to hold the ...
...are oxygen sensor 3 in bank 2 (PO165) and PO155 is a malfunction in heater circuit for oxygen sensor 1 in bank 2. do both oxygen sensors need to be replaced Yes sorry but they both should be
...OF THE CAR)STARTING AT FRONT IS CYLINDER 1 THEN 3 THEN 5 THEN THE LEFT BANK IS CYLINDER 2,4,6, FRONT TO REAR... THE COILS FROM LEFT TO RIGHT (STANDING IN FRONT OF CAR) ARE 1,4,6,3,2,5 HOPE THIS ...
...bank 2 sensor 1. Have your oil and filter changed right before you go for a retest to. That will clear up 3 codes P0300, 0155 and 0154. You might have to replace the fuel sending unit to get rid of ...
...bank 1 (right) P1550 is: Power steering pressure sensor out of self test range. Well the ECM recognizes 3 codes. Were these codes stored as inactive (in the history section)? Or are these codes all ...
Question about Isuzu Rodeo
...bottom see those hiddencoil packs mail coils molded to case? if you are wired right and you have cross talk from 1/4 to 2/3 bank the pack is bad. by cross talk i mean, 1;3 effect 1/4 or the
...and put front lobes of camshafts in position shown in picture with cam gear timmed up at same point cam gear are 3:1 ratio look closely at cam gears in pic to see front lobe positions for both ...
Question about Isuzu Rodeo
...bank capacitors to self discharge. if it takes 10 min, so be it, the caps can be 2x better than labeled in the real word. (micro farads) in electronics it's 3 time constant's or about 0.7v volts, it ...
879 questions posted
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
547 Questions