...clutch pedal on Suzuki vitara two litre V6 1998 goes to about inch of floor before activation. Clutch does not slip just too much pedal travel. Is it possible to adjust it? Thanks. Ted Clutch ...
clutch pedal to the clutch master cylinder to take the slop out of it. You would feel that kind of slop when you push the pedal down. Clutch is good for about 10 years of normal driving, so you are at
...clutch pedal was low and grumpy when pressed and hard to select 1st or reverse. plenty of movement in clutch slave arm and no fluid leaks to be seen.so i removed the gearbox to fit new clutch hoping ...
Question about Suzuki Vitara
Hi Have a broken clutch cable on my 1996 suzuki vitar but can't seem to pull it out from the Clutch release arm which has a joint pin attacted USA car we are usa, and our cars are not like cars ...
clutch- I have seen that happen time and time again. Try of engaging the emergency barke instead of pressing the brake pedal and see if that makes a differnce. Let me know how that works for you! Good
...clutch pedal is pressed or they do have the clearance but are failing to separate. Air in the hydraulic system, worn or maladjusted linkage or cable are the common causes of the first and oil/grease ...
Question about Suzuki Vitara
pedal for a sec then it goes into overdrive but take a while to go any faster than 50 mph. Where do I start? low power is caused by many things. 1: dragging brakes or very low tire pressure (dangerous
...clutch adjustment Location of the adjusting bolt is just above the pivot of the pedal. Loosen the locking nut then make the necessary adjustment. Dont forget to tighten the lock nut once
...clutch pedal went to the floor and wont come back up. It's like its stuck in perpetual neutral. Slave gear? Where is it. Check the fluid level on the clutch master in the engine compartment. The ...
641 questions posted
Usually answered in minutes!
119 Questions
102 Questions
89 Questions
65 Questions
16 Questions