2001 Chrysler PT Cruiser "engine torque setting crankshaft 1" Questions

...engine with a jack. Discharge A/C system and disconnect A/C lines at coupling block Remove upper torque strut Remove screw attaching ground strap to strut bracket. Remove torque strut bracket from ...

...Torque settings for Crankshaft & Cylinder Hrad Hi I have a Opel Corsa utility 1.7D I am doing the hole engine over but I need the setting for it 2000modle Corsa and the engineers are rebuilding the ...

torque settings. Ford Workshop Service and Repair Manuals > Transit ... Workshop Manuals https://workshop-manuals.com > engine > page_1261 Stage 2: Tighten an additional 90 degrees (one-fourth turn

...engine must be cold). Install components in reverse order of removal. Fit cranckshaft pully. Tighten crankshaft pully bolts 8. G4-J: Tightening torque: 12-15Nm. G4-N/G4-k: Tightening torque: 10-12Nm ...

...engine mount through bolt and torque it to 87 ft. lbs. (118 Nm) Upper radiator support crossmember Torque strut bracket Upper torque strut A/C lines and pressure switch Exhaust system to the manifold ...

...Torque Sequence Fig. Main bearing torque sequence-2.4L engine Fig. Main bearing torque sequence-2.5L engine Fig. Main bearing torque sequence-3.3L engine Fig. Main bearing torque sequence-4.0L ...

...the RH front wheel. Tightening torque :88.3 ~ 98.1N.m (9.0 ~ 10.0kgf.m, 65.1 ~ 72.3lb-ft) 19.Install the engine cover with bolts. Tightening torque :3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~

...Engine mounting and bracket. Timing belt upper cover [1]. 3. 4. Turn crankshaft clockwise to TDC on No.1 cylinder. Ensure timing marks aligned [2] & [3]. Remove: Crankshaft pulley bolt [4]. ...

...torque engine mount. 3 right side upper engine torque axis to front cover nuts and the 2 mount to midrail bracket nuts, allowing the powertrain to rest on the block of wood Drive belt, tensioner and ...

130 ft.lbs. (167?177 Nm.) VQ30DE engine ? 29?36 ft.lbs. (39?49 Nm.) followed by 60?66°clockwise angle torque Install the drive belts to the crankshaft damper; be sure to properly set belt tension