1999 Jeep Wrangler "repair replace shifting cable" Questions

Replace ignition switch on 99 jeep wrangler The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.REMOVAL 1. ...

...repair. "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info." Shifter cable install 2003 trailblazer Replace ...

...dash. Question edited for clarity. Question moved to model category. You may not need to replace, you can repair. ...

...Replace shift cable 1997 Explorer Automatic Trans. 4wd start at the throttle linkage and disconnect there follow routing of old cable and place new one in same was old cable and finish at the ...

...repair the gear shift? I have a 1991 Wolfsburg Jetta automatic and the gear shift is stuck in drive. The shifter moves but doesn't change the transmission. Locate where the shift cable linkage mount ...

...just snaps in to place - is that correct? Can it be fixed without replacing the entire cable? the ends snap into place i haven't seen a repair kit  so the whole cable needs

...replace just the switch but if wires go into switch then shifter needs to be replaced. you have to pry shift cable off the shift lever pin with a small thin flat blade screw driver.to disengage shift ...

...cable? The end fitting that clips onto the ball joint on the transmission shift selector has broken and comes off of the ball joint. Is there an easy repair? you have to replace the entire

...repair? Go to Step 12 -- 10 Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement . Did you complete the repair? Go to Step 12 -- 11 Replace the ignition lock cylinder case ...

shifting properly some say i need a torque converter when it shift it shifts hard Check to see if the throttle shift position cable that goes to the transmission is sticking or that the return tension