1997 Jeep Grand Cherokee "ball joint wont back" Questions

Ad

Question about Jeep Grand Cherokee

3 Answers

...ball joint. The upper ball joint then needs to be driven out of its bore by means of a pneumatic air hammer and proper attachments, and a new pressed ball joint installed only after you install the ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...ball joint back in place 1996 jimmy blazer 4x4. just replaced the upper & lower ball joint. only thing I'm having problems getting the upper bolted on.. i think the shock isn't helping either. I've ...

Ad

Question about Jeep Grand Cherokee

1 Answer

ball joint wont go back on i have recently removed both my front hubs on my 2003 tiburon. now that i am ready to put them back on the lower ball joints would go back on. i place the nuts on and try to

Question about Jeep Grand Cherokee

1 Answer

...ball joint just went. Isn't is something they should have looked at while doing the alignment? And can someone give me an idea of what kind of cost I'm looking at to have fixed? Thanks to anyone that ...

...ball joint if you have knocking noise a sort of rattle on rough road or over bumbs then this is 100% the bottom ball joint these are cheap to buy and its best to replace both sides as you will only ...

Question about Jeep Grand Cherokee

2 Answers

...wheel up and down. if it moves.. the ball joint needs to be replaced. repeat those test on the other wheel as well. checked your p/steer oil latley and is the p/s pump pumping

...ball joint and the two other rubber bushings installed. you just jack the car up by the frame until the strut is fully extended. loosen the ball joint clamp bolt and a couple of hits with a sledge ...

...ball joint as you can go and jack till the tire is about 1-2 inches off the ground stick a bar under the tire and pry the tire higher off the ground and release repeat this till you can confirm ...

Question about Jeep Grand Cherokee

1 Answer

...ball joint spreader tool at most auto tool outlets. or put nut back on ball joint shafts so stud top is protected but a gap (still loose) and hit the side of drag link where the ball joint stud goes ...

Question about Jeep Grand Cherokee

1 Answer

...one wheel so it can't transmit power. You will have to disconnect the lower ball joint again, move the lower control arm down a bit, so that you can push the axle into the splines of the

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

3,380 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...