Question about Jeep Grand Cherokee
...dealer replaced 3 months later it's bucking at highway speed dying at 30 40 mphs engine light comes and ges only code p0601 Hi Charity,here's a link on your P0601 code. ...
engine, check the codes 300, 301, 306, 442, 456. Turn it back on. Everything is fine again. I would start with a test drive with a fuel pressure gauge on it make sure you have spec. 35 - 40 psi. Clear
engine code 40 if it's po400,it would be the egr flow low. TIM............
...40 mph it have no power at 40miles possible blocked cataletic converter , blocked air or fuel filter if you have check engine light on what codes do you have. if this was at all helpful please leave ...
...fuel level more than 1/2 full, engine running, EVAP leak test "on", and the PCM detected a leak greater than 0.040� but less than 0.080" somewhere in the system. This code sets in 2
...engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once ...
...40 - 60 MPH. New ground wires have been used to engine frame and body. Hello Lubie... I would STRONGLY recommend you get your codes read... I TRIED ALL that TOO... Finally my codes... said the OXYGEN ...
...40 mph and the check engine light blinks on and off. No codes except to tell me that cyls 1, 3, 6 misfired. Cleared and reset the computer and ran perfect. Next day, the problem came back. Hello, I ...
...engine cuts of what do you think is problem. Could be idle air sensor or throttle position sensor but first run the code check. On Jeeps you turn the key on and then off (without starting it) three ...
ENGINE LIGHT ON In the Grand Cherokee WJ, the MIL gives an indication to the vehicle operator when the Powertrain Control Module (PCM) has recorded a Diagnostic Trouble Code (DTC) for an On-Board ...
3,380 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,639 Questions