2006 Subaru B9 Tribeca "remove wire retainer bulb cover" Questions

...wire clip is as easy to replace as it was to remove. Push it forward and up. Again, it will snap into place. Replace the 2 electrical leads, and replace the screw on end cap. Test the headlight. BE ...

wire goes where. Push the retaining clip in and down towards the ground. It should open about 100-110 degrees. Remove old bulb. Install new buld with square side toward the ground. There is a guide in

...remove the runner cover, plastic cover, retaining wire... use a small mirror to locate which direction the tab should be facing. install the bulb while holding the retaining wire out of the way. once ...

...retainer away from the rear of the headlight assembly. Grasp the bulb securely and remove, noting the location of the alignment tabs for installation. Allow the bulb to cool before removing it from ...

...remove the 3 bolts that hold the headlamp in place 2 at the top and one down at the bottom of the headlamp on the inboard side. Pull out on the outboard bottom part of the headlamp to release the ...

that has been removed. DON'T TOUCH THE BULB ! as this will damage it! Normal: Remove the round cover and the bulb will be exposed !, remove wire connector and un clip the retainer spring, replace bulb

bulb/socket counterclockwise to remove from the headlamp assembly. To Install: Connect the wiring harness to the headlamp. Install the headlamp bulb/socket to the headlamp assembly rotating the socket

...remove the wire, push the wire down and towards the passenger side of the car, it will dislodge and you can then lower it to remove the bulb. Once the bulb has been changed, you want to replace the ...

...Remove the cover. Disconnect the wire harness clips from the headlight blades by pulling them off. Press in and then upward on the headlight retaining ring holding the headlight bulb in place. Remove ...

...remove the plastic dome cover, and then the bulb connections, un clip the bulb retainer, extract the bulb, and check with the new one that its same. No fingers on new bulb or it will pop when you ...