1991 Honda Accord "replace clutch" Questions

...low or empty you have a leak or component failure. Visually inspect clutch master, line, slave cylinder for fluid leaks. replace as needed. If hydraulics are o.k., suspect clutch disc/pressure

...replace the clutch plate and most likely the clutch release bearing too. You could keep running the car, but if the broken pressure plate part falls out, you could have an even more expensive repair. ...

...clutch issue-however, if it does this again, your car is at a prime age to have issues, and you might have to go through and replace parts.  May I recommend a Chilton/Haye's manual?  ...

I replaced clutch master cylinder and clutch release cylinder,bleeding system still don't have clutch pressure. Clutch pedal doesn't have pressure. If you can press the clutch fork ( the part that the

clutch at bleeder screw on slave cylinder and make sure there is pressure from master cylinder. If there is pressure then slave cylinder may be bad replace slave and bleed and that should take care of

clutch pedal. Before replace parts I had pressure but occasionally espeically in first or reverse it would stick having to manually lift the pedal back but not I can get any pressure to the pedal. Not

...replace the Clutch Master Cylinder or the Clutch Slave Cylinder or both? Also, is there somewhere there might be another fluid leak? Thanks for you help. if it,s hydrolic look to put in fluid. ...

...replace both the clutch slave and master cylinder clutch slave cylinder is possibly leaking. do a visual check. with help of another person , without vehicle running have other person pump clutch ...

...replace the clutch disc, pressure plate and throwout bearing< really? the first thing, for all hydr. clutch actuators is to test it with 2 persons. you depress clutch and person two ganders at the ...

...but very commonly a repair shop will wish to replace the clutch and the compressor both, instead of just the clutch. The cost can be high. ( $500 - $1000 parts & labor) God bless your