1999 Acura TL "reset engine light" Questions

reset engine warning light how do I reset engine warning light on a 1999 acura 3.2 tl To reset the Engine Light, you'll need a OBD II scanner. It cost about $100. Or, you can go to you local ...

...reset button, then turn key on, but don't start engine, wait approximately 15 seconds until maintenance required light stops flashing. Turn key back off. Turn on again without starting if reset is ...

...online for $79.95 which reads all cars from 1996 on. It will also reset faults or engine trouble lights so you can see if they re-occur. You'll save the cost the first time you use this handy

...Engine light by either disconnecting the battery or by using a code reader to clear the codes. However, if the problem still exists it will come right back on. Instead you should get the code read, ...

...engine off.push the reset button on clock control panel for 3 seconds,then turn off ignition switch.then turn back on the ignition switch the maintenance light should be off is so.it has

reset check engine light on Acura TL 1999 i dont know how else to do it other than with a diagnostic tester. i think that may be the only way. Unplug the negative of your battery for about 10 min Then

engine light on how do you reset? The best way is the next time you are out and about, stop at an autoparts store and they can reset the light using a scan tool. Most parts stores will do it for free.

...engine stays on. Hi,welcome to fix ya. That light is there to remind you its time for service . it starts out flashing then when the service is past due it stays on solid . heres the reset ...

...on tehe dash board? With the ignition off, push and hold the odometer reset button while at the same time turning the ignition on but not starting the engine. After 5 seconds the light will

...engine lights or service lights for free. It could be something else that needs looked. Normally. The oil change shops reset the service light for you. Hope it helps It means the place that did your ...