...thermostat and gasket to the block to the manufactures torque specs. I would buy some radiator flush if it has not been flushes for several years. Fill the radiator with the correct ratio of coolant ...
...making sure to orient the thermostat the same way as the original. install gasket using water rated gasket seal and torque the bolts to specs. let set for several hours, refill radiator, and ...
Question about Honda Accord
...thermostat on a 2006 Kia Sorento and would like the torque specs to tighten the water inlet housing bolts back. Here are the instructions for installing your Thermostat. 2.0 and 2.7 are basically the ...
...in if needed, use a new gasket or gasket goo to form a new gasket. Return housing, bolt down to torque spec. Replace air cleaner , top hose and add coolant. Too easy, wont take hardly any time at
...torque thermostat bolts down according to manufactures specs (torque) (pound per sqr inch). replace coolant and make sure the mixture is at manufactures specs for your weather. 5 Run engine for ten ...
thermostat housing is bolted to this cover. it has (4)10mm bolts that hold it on. 7. using the special tool, turn the water pump clockwise (it twist-locks into the housing) and remove it. 8. clean all
Question about Honda Accord
...Torque Strut 54 40 - Exhaust Manifold-Bolts 23 - 200 Exhaust Crossover Pipe-Bolts 54 40 - Intake Manifold - Lower-Bolts 23 - 200 Intake Manifold - Lower Gasket Retainer-Bolts 12 - 105 Intake Manifold ...
...thermostat housing because they wear out from the inside out and may spring a leak after removal and replacement, usually around the three tabs where the bolts go through. Mine started leaking when I ...
torque to manufacturer's specs. Attach the pulley to the water pump hand tight and put the belt back on. Tighten the pulley bolts. Put the coolant recovery tank back in place. Fill with coolant, start
...torque spec for that particular set up, so you need to find out what the torque spec is and don't go past that. Next make sure you don't use any kind of silicone or form a gasket. Just use the O-ring ...
2,213 questions posted
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,636 Questions
1,570 Questions
1,470 Questions