2002 Land Rover Discovery Series II "td5 engine problems" Questions

...no problems and sound fine. check the choke and the timing TD5 engine turns over for up to a minute and gradually fires up. No smoke. Once running no problems and sound fine. But know dos'nt ...

TD5 engine turns over for up to a minute and gradually fires up. No smoke. Once running no problems and sounds fine. But know dos'nt start I think u may have a injection pump problem, have it checked ...

...td5. over the last few months it has developed a misfire when pulling from 1250 revs and beyond i have had it on the computer at 2 different landrover garages but it never shows a problem check fuel ...

...engine. I'm just a novice in these matters, but my td5 auto developed the same sort of symptoms and it was a front wheel bearing. Jack each wheel up individualy and give em a good rattle. If theres ...

...td5. 1999 model. What could cause this when the head was reconned 12 months ago This is typically a sign of a bad head gasket. You may want to check your oil for water / antifreeze. While oil in the ...

...td5 x reg it drives fine until yesterday then pulling away there seems no power ther are no other problems just no power drives fine is the check engine light on? if not i would have the fuel filter ...

...td5 54 plate gear problem local driving ok problem starts when on a run gears go stiff on tight run gearstick acroos in neutral and if feels like metal greating . swithch engine off and gears ...

...td5 want start when cold dear friends, i have changed the fuel pump after it was noisy and really hard to start and the filter too, now it wont start after a while. the more you leave it parked the ...

...Engine has FSH and has done approx 60000 miles. check for oil in the injector loom going to the ECU known problem with the Td5 could also be the air flow meter starting to give trouble I have a 97 ...

...td5 poss immobiliser prob switching off engine key separated from fob now will not start have tried emegency key access as per manul but my code contains a 0 and can not then enter code correctly If ...