1998 Toyota Camry "valet switch" Questions

...valet switch and press it while turning the key from off to the run position, release the valet switch and everything will likely work fine. With all of the electrical feautres on these and simlar ...

theft deterrent system the theft sytem is locking up. we have no remote transmitter, all we have is the key. the transmitter is lost. how do we bypass the Valet Switch options? Get the alarm removed.

...valet switch. It should either be a push button or toggle switch that will allow you to turn off alarm. Either way you will need to turn the iginition to the run position then activate switch. If it ...

...valet switch might be the toggle (on/off) type. in this case, key on, flip switch in opposite direction, then turn the key off.) This should reset the alarm, and reset the grounded relay on the ...

...switch so you can put the starting system back into the valet position. If not this is going to be a headache to you. You need to decide to have either have the current unit removed from the car or ...

...valet/overide button, it's a hidden device-switch, a little spring loaded micro button, red or black possibly and is probably down under the dash area, near your knee/leg. In some remote start/alarm ...

...valet all the time. i was able to remove airbag from stering wheel but without a color code i wasnt sure where to check for continuity? also there is a simple ground wire attached to the backside of ...

valet) switch. When you locate it, turn on the ignition key, press and hold in the button (little spring loaded micro button, red or black possibly)until the alarm chirps 1 time. This should over ride

switched the valet switch to get it to beep again but it will not beep lost the manuaL (glove box opr man.) its here, read it. RTM http://justgivemethedamnmanual.com/toyota/toyota-camry-owners-manuals

...the alarm, and reset the grounded relay on the starter wire, allowing you to start the engine. the valet switch is by driver side kick panel look for small button may be stuck in wire harness to ...