...tension on the alternator belt and it stalls. why? this could be a clutch problem, i encountered a similar situation not so long ago,skim over your clutch setup, if the clutch was slightly engaged ...
I need the diagram for the a/c belt for 1995 Toyota Corolla I think my a/c clutch is locking up & causing ''noise''. I was wanting to find out what else if anything was run by that belt in case it ...
...tension, your description sounds like loose belt(s). Do not use belt dressing, only resolves for short period of time... Doc The noise is probably the A/C clutch on the compressor. If you have A/C ...
Question about Toyota Corolla
...clutch of compresor and c) finally check the tension of belt for compresor for mechanical tight.Use the same capacity of fuse and wires the same capacity. Do not use ANOTHER .see the diagram use the ...
Question about Toyota Corolla
...clutch pressed), when I am turning the steering wheel, it is creating a constant noise. I removed the hood to find the source of the noise. Apparently the noise is coming from the passenger side of ...
...pulley 28678Belt idler pulley 33A733Power steering pump pulley 48620Drive belt 519D784A/C clutch pulley 66B209Drive belt tensioner pulley 76A312Crankshaft pulley 88A528Coolant pump pulley ...
Tensioner Will Allow Belts To Slip. 6 Inspect Belt Tension Incorrect Belt Tension Will Allow Belts To Slip. 7 Inspect A/C Clutch Pulley/Rim Misaligned A/C Clutch Pulley/Rim, Seized Bearing, Loose Belt
...tension on clutch peddle i just replaced the clutch on a 1996 geo tracker.we put it back in and now we dont have any clutch peddle tension.did the throwout bearing come off its mounts when we put the ...
Question about Toyota Corolla
HOW TO REPLACE BEARING IN MY AC CLUTCH OR RELPACE ....2002 TRAILB HOW DO I REPLACE THE AC CLUTCH AND SERPINTINE BELT TENSIONER IN MY 2002 TRAILBLAZER belt tensioner just unscrew
Question about Ford Cars & Trucks
...pedal lost all tension although returns up after being depressed. car will start if pedal pushed to floor but no clutch tension Master or slave cylinder blew out. Could be the pressure line
725 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions