...starter relay, the neutral safety switch, and replaced the ignition switch to no progress. I also use an OBD II sensor and no codes were found. I tested to see how many volts are going through the ...
...neutral safety switch cause I thought that was what it was, lots of power in the dash...any thoughts? check starter,starter fuse,relay. TIM........... Yes but when you eliminated the switch did you ...
Question about Toyota Corolla
...replace it. (Take off the negative battery cable from the battery first to remove the starter from the vehicle.) If jumping the starter caused it to operate, the starter and solenoid are good, and ...
...replace it? 2) Are the ignition switch and the neutral safety switch the same thing, if not, then where and how do you replace the ignition switch? 3) The location and easiest way to change the ...
...neutral and starting it that way, but had no luck. I?ve also tried jump-starting it, but no luck. The battery and connections are brand new (3 days old). I?ve had the alternator and battery tested ...
...to hotwire, replaced neutral switch, relay, and ignition it could still be your battery, you need to run a load test (need a testing device). If battery checks out ok, need to check your
Question about Toyota Corolla
...the key switch and the neutral safety switch for power ? Its possible jumping the battery was just a coincidence. There is also a possibility the starter is not good even tho you have replaced
...starter switch, the neutral safety switch, the contacts in the starter solenoid, or the battery itself. Coming from a Toyota tech, it sounds like the starter contacts are worn and time for a starter ...
Question about Toyota Corolla
...starter. Started up after replacing both. Turned the key off to check again and then nothing again. Anyone have any ideas? Ignition switch, neutral safety switch or fuse? was it a new battery if not ...
...Neutral, have the parking brake set and use wheel chocks to prevent the starter from engaging with the trans in gear. Most of the time it is mounted in the gear select mechanism you will need to ...
1,142 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions