Question about Pitco Frialator Kitchen Appliances - Others
...with a good one before using the unit in cooking. Hi limit is the safety device of fryers responsible for shutting the gas valve in case oil temp reaches 450f to avoid oil from catching fire.
Question about Imperial Kitchen Appliances - Others
...test the Pitco Frialator 35CS high limit switch remove connections from hi-limit switch, and put an ohm-meter across connections then heat it with a match or heat source of that temp range,heat the ...
test the switch with a meter or a jumper (for TESTING ONLY!). Remember, the hi-limit switch may be doing it's job and be the symptom, not the cause. But if the switch is tripping open prematurely, you
...hi-limit and jump it out,there should be 2 wires take them off and connect them directly.set the dial to 350,wait until the burners shut off and test the temp of the oil again.if it matches your ...
Question about Imperial Kitchen Appliances - Others
hi limit to test this also, and it still goes off, you need a thermopile. If it stays on, check your temp with a reliable thermometer, and see if it reads fairly close to your setting, if so, then you
...of dirt. The gas pressure must be sufficient and all wiring should be tightly connected. Check also the hi limit, it should have continuity across its terminals when tested with an ohm meter.
...of voltage to energize pilot and main valve coils of the gas valve. The pilot flame quality must be good. Hi limit must have continuity across its terminals when tested with an ohm meter.
Question about Pitco Frialator Kitchen Appliances - Others
...test this with a multimeter, one side to the thick copper wire coming from the pilot, and the other at one of the hi-limit wires, DC voltage please. Grease could be on/in any of the aforementioned ...
...hi limit if it is good (has continuity across terminals when tested with an ohm meter). The thermopile should be free of soot or any form of dirt. Gas supply should have sufficient pressure.
...hi limit is bad if the oil gets too hot the hi limit will shut everything down for safety or if the oil temp is good it is the limit control shutting everything down when if should not first thing to ...
317 questions posted
Usually answered in minutes!
16 Questions
4 Questions
4 Questions