Remington Electric Chain Saw  "sprocket cover" Questions

Sprocket cover tab (located on the round part of the sprocket cover) isn?t inserted into the saw body tab slot. Or your cahin is not tensioned properly. According to the manufacturer... "The adjusting

...sprocket replace the bar, chain and cover and try turning it again by hand. If it doesn't turn don't try to start the saw as you'll do damage. If the chain was on properly and it still won't turn the ...

...cover, loop the chain over the nose of the bar, and then loop it over the sprocket and off the saw, the bar will now lift away, to refit, place the bar back onto the bar bolts, push it fully back ...

...cover, or on the front of the saw, push the guide bar fully back toward the sprocket, loop the chain ocer the sprocket and lay it around the the guide bar, make sure the cutters on the top of the bar ...

...sprocket cover for model 111174 missing nut and sleeve for sprocket cover Duplicate question... duplicate answer. You provided no model number. It is probably here: Remington.com ...

Hi, I'm looking for a Husqvarna 365 chainsaw sprocket cover Hi I'm looking for a sprocket cover for a Husqvarna 365 chainsaw No response to CR.

cover and the sprocket attached, remove the little E clip in the centre and the cover will come out be careful not to loose the little roller bearing, To replace lube the roller bearing DO NOT get oil

cover was part no. 501686004, however if it has a single piece ignition system it will be part no. 503610003 the clutch bearing depends on what sprocket is fitted, if it is a spur sprocket the bearing

...cover, loosen the bolts to allow the bar to slide toward the sprocket. Lift chain off the sprocket and pull out from the notch in the bar. Be sure to turn the chain the same direction, otherwise you ...

...sprocket, so to remove you need to remove the side cover nuts and take away the cover, the bar and the chain, there is then an e clip on the end of the crank, insert a suitable screw driver into the ...