Husqvarna Forest & Garden 125l 18" Gas Trimmer "adjust weedeater" Questions

...adjust the carburetor on a weedeater with out a special tool? the weedeater will start and run on full choke but when take of full choke it stall like it not getting enough gas want take the gas ...

weedeater at full throttle. The LO is for the adjusting the idle. Try these steps: 1. Adjust both screws clockwise until just seated (tight) using the correct tool (from a set similar to the one above

Why does my weedeater stall when i give it gas? how to adjust carbs on 2 stroke weedeaters and chainsaws Davidsfarmison...

...hard to start. Got it to run and it idles fine. When you start to weedeat, it dies. Going to try to adjust the carb. try winding the mixture screws out a ...

I need to know the preset adjustment on the low and high idle on a stihl weedeater (ex. 1 1/4 turns) all 2 cycle weedeater type carb diaphram presets / initial settings are 1.5 turns after a gentle ...

...WEEDEATER MODEL 85. I BOTTOM OUT THE SCREW THEN BACK IT OUT 1 1/2 TURNS. IT STARTS WITH A BURST AND RUNS A FEW SECONDS ON FULL AND 1/2 CHOKE THEN DIES.WITH THE CHOKE IN "RUN" POSITION IT WONT FIRE AT ...

...both high speed and low speed settings. ther is no set setting but to get it to run so it can be adjusted. lightly close the high off then open the low about two turns. try to start if starts ...

...weedeater starts and runs great - in 'start'. As soon as I pull the throttle and it switches to 'run', it dies on me. Its only a year old and its done this since new. Help :-| Sounds like the ...

...and replaced the carburator the book manuel just change the way the carburator works. The vaccum adjustment are not there and all that need is the idle adjustment. But, the new carburator doesn't ...

...adjust the idling screw on a lot of weedeaters there is a holddown nut collar that secures the weedeater throtlle cable to the motor housing . if you removed the cable from the carbuerator and ...