...clean, & no obstructions in jets. soak bowls also.squirt through carb. air & fuel circuits w/ spray carb. cleaner.when everything is cleaned, reassemble carbs. check carb. float needles for leaks. if ...
Question about Husaberg Fe 400 E Motorcycles
clean, I can't get it to start without spraying some carb cleaner down the carbs and it'll run for a moment then shut off ( ... Carburetors & Parts for Honda CBR600F2 eBay https://www.ebay.ca > ..
Question about Husaberg Fe 400 E Motorcycles
...problem i would just like to save u some time... but if you are 100% sure this is not it then clean the carbs and new needle valves CLEAN THE CARBS AND SERVICE IT!!! it will run like a dream
...clean my carbs will l have to adjust the pilot screw or sync the carbs --- is that going to happen by cleaning or replacing parts such as needle jet, needle valve, and carb jets? Syncing the carbs ...
Question about Husaberg Fe 400 E Motorcycles
...clean all those carbs) Well, a couple things may be wrong. 1) debris could be lodged under the needle valve. Remove the float by gently slideing the float pin out, the needle will either slide out ...
Question about GAS Motorcycles
I have a klx300r. I just got it and it had been sitting for a couple years prior. I cleaned the carb and it had green coating all inside. I think they ran mixed gas through it. It runs but you have to
Question about Husaberg Fe 400 E Motorcycles
Ozark 250 will idle, but when throttle is pressed, it seems like it is starving for gas. Cleaned fuel shut off valve and screens, drained carb, replaced spark plug, any idea? clean air filter, and ...
...clean carbs, fuel lines and replaced fuel filter cleaned tank and added fresh fuel, and bike started started right up, but next day bike wont start again so I pulled carbs and cleaned out again and ...
Question about Husaberg Fe 400 E Motorcycles
...on bike runs and revs up ..take choke off bike idels but wont rev up ..it back fires n pops..i cleaned carb and it getting gas to carb.. It sounds like the jets in your carb are stopped up. It ...
...carbs off i suggest cleaning all passages with carb cleaner!! Use little red nossle to spray into each jet and see where it is suppose to come out. Manually remove each jet one at a time and clean it ...
2 questions posted
Usually answered in minutes!
5 Questions
3 Questions
1 Questions