1980 kawasaki KE 125 "clutch adjustment" Questions

...adjustment of the clutch lever. This means when you pull in the clutch you should not feel any resistance for the first 1/4 clutch lever travel. also when trying to undo clutch centre nut, put the ...

how to hook up a clutch cable The clutch cable has one end that goes into the lever on the handlebar and the other end with an adjustable lock nut that goes into the lever on the engine. Firstly make ...

we have 75 125 ke. my son developed a problem where as soon as you release the clutch , it surges forward then dies instantly, i've tried adjusting clutch cable but with the same results, could ...

...adjustment is correct, tighten the clutch in-line cable locknut and slide the rubber boot over the cable adjuster. 10. Install the clutch inspection cover quad ring onto the primary chain case ...

...adjustment is correct, tighten the clutch in-line cable locknut and slide the rubber boot over the cable adjuster. 10. Install the clutch inspection cover quad ring onto the primary chain case ...

...clutch rod adjustment Slide the rubber boot away from the clutch cable adjuster. Loosen the cable locknut and turn the adjuster to provide as much cable slack at the clutch lever as possible. Support ...

...adjustment at the clutch lever Remove: - Left Side Cover - Clutch Adjusting Cover Loosen the locknut Turn the adjusting screw in until it is lightly seated - Be careful, the screw will keep turning ...

clutch lever and make the adjustment there as needed to get the clutch wear you want it, if the clutch is slipping you may need to have the clutch replace. try to adjust but if the adujster is all the

...clutch adjustment is made at the handlebar. Turn the adjustment screw on the handlebar out until the clutch lever has about 1/8 inch of movement (before any tension is felt on the clutch ...

How do i adjust the clutch on my 2004 Harley Davidson Heritage Softail Manual says back out clutch adjusting screw 1/2 to 1 full turn. When I do this and then set the handle adjuster as per specs the ...