2002 Kymco Stryker 125 "brake master cylinder" Questions

...seals or brake line, depending on whats leaking. The master cylinder and brake line can come off ANY bike as long as they are the right length (brake line) or fit on the handle bars (master

...brake lever is released it could be a problem in the master cylinder which diagnosis would normally require disassembly of the master cylinder, although loosening the hydraulic fitting right at the ...

...master cylinder. Press the rear brake pedal and hold it down. Open the bleeder valve on the rear caliper and allow brake fluid and air to bleed out. Close the bleeder valve. Let off on rear brake ...

...brake master cylinder is bad, or your bleeding procedure is not correct. Let's take the simple one first, your bleeding procedure. This is easy to get confused on but it must be done in an exact ...

...brake line onto the master cylinder and pumping the lever a couple of times till the brake fluid gushes past the sealing washers. Then tighten the banjo bolt and bleed the lines. Once the master ...

brake shoes to the drum. Very important, DO NOT ALLOW THE MASTER CYLINDER TO RUN DRY DURING THE BLEEDING PROCESS. Make sure that the small hole in the bottom of the master cylinder is clear. Good Luck

...brake pressure after master cylinder change? Had brake issues last season, ended up being the master cylinder reservoir sight glass was cracked. I just used some glue for temp repair and it worked, ...

...master cylinder. Work the rear brake pedal slowly a few times and top the master cylinder off. Lay the top of the master cylinder on top of the master cylinder to keep down any fluid splashes. Now, ...

...brake fluid in the master reservoir. Place the sock into a used zip lock bag and discard. DO NOT touch the clutch/brake lever or you will draw air onto the system. Now fill the reservoir with DOT 3/4 ...