Question about Kymco Venox 250 Motorcycles
1989 vt1100c motor oil to reduce engine ticking 1989 vt1100c what motor oil would be recommended to reduce engine ticking 20W-50 is good for muffling sounds in the motor. Depending on the loudness the
...i just runs good except for a ticking sound could it be valve trouble? Have the valves adjusted at the proper interval. Sounds lilke a loose valve, nothing too serious. Just needs to be adjusted
should a 2 stroke tick over? should my 2 stroke yz 125 tick over or should i have to keep touching the throttle to keep the bike going? you just need to adjust your carb mixture screws located on the ...
ticking noise. Is there an easy way to adjust them without damaging my engine and not spending tons of $$$ taking it to the shop? They are supposed to tick a littlle. It's when they get tight that you
Question about Honda Motorcycles
Honda bike 160cc engine, cold start tick-tick noise after few seconds that disappear . What is the cause give solution is it dangerous Valve clearance need adjusting a fraction. not dangerous, better ...
...ticking/clicking noise? What could this be from? Could it be my valves? Could the valves be self-adjusting or do they have to be manually adjusted? Is there a DIY manual that I can download for free ...
Question about Kymco Venox 250 Motorcycles
why does my 2003 drz 125 have a ticking sound when i run it? Also a four-stroke has the tendency to tick somewhat unlike the 2-stroke. If it seems too noisy or the ticking is more like a rattle have ...
Question about Suzuki Motorcycles
2002 Katana GSX600F. Is it normal to hear a slight ticking sound? Bike starts and runs well. just hearing a slight ticking sound It is normally Tappet Tick. The valve lifters need a bit of a tighten ...
bike has annoying ticking noise from mostly rear cyl..bike is a 2000 shadow spirit, with 33000 miles, i was told valves needed adjustment at 30,000 miles , along with timing chain adj.. is this ...
dont thinking thats the timing chain. ant suggestion? If it isn't the cam chain then it is most likely a ticking valve tappet. Have the valves adjusted and inspect the cam lobes for damage or scuffing
19 questions posted
Usually answered in minutes!
22 Questions
16 Questions
1 Questions
3 Questions
2 Questions