alignment test should verify this. It could also be a front suspension fault i.e. un-even adjustment of suspension settings (if it is adjustable) or incorrect fluid levels in the forks, or a bent fork
...fork legs, and retighten the nut again? the bike is a VL800 k5. Loosen the front fender, the axle retaining bolts, plus the upper and lower headstock bolts and nuts so that the whole assembly is free ...
...alignment but the bike is still pulling to the left when i let go of the handlebars check tire pressures and tire wear condition. may be time to have front fork bearings serviced and fork fall away ...
...just twisted in the housing one of the forks ,, check the alignment of each , if it just twisted loosen the bolts for the hold downs of the fork assembly and align, if its bent ,, you must replace ...
...from the handlebars and go in a straight line I have to transfer my weight to the left side. The alignment appears to be correct. The bike has done only 8,000 miles and has never been dropped. Any ...
...fork alignment. 3. Check for freedom of rotation of the rear fork around the bearings and that the fork and frame side members have not been distorted when the pivot shaft nut was tightened. 4. ...
...fork legs and align the steering with the front wheel, but after re-tightening the bolts the alignment just goes out again. What am I not doing right, or is there a more sinister fault than I am ...
...fork tubes are out of alignment. This could be caused because the upper and lower tube guides have been knocked out of alignment, because one or both fork tubes themselves are bent, or a combination ...
8 questions posted
Usually answered in minutes!
3 Questions
5 Questions