2005 Honda VT 750 DC Shadow Spirit "idle adjustment" Questions

...idle speed should be 950 RPM to 1000 RPM. 9. Faulty neutral, side stand or clutch lever safety switch. 10. Air/fuel mixture screw improperly adjusted. 11. Accelerator pump damaged or not working. 12. ...

...adjustment really, only by the amount of choke you apply. Also remember, never use the choke if the engine is already warm. And, only use the choke for the first start of the day, when the engine is ...

starts and stays running with choke on. stalls when choke is off at idle. back fires also. changed plugs, fuel filter,cleaned air filter. Is there something Im missing before I pull the carbs to clean

it idles fast if I turn the idle down it stalls running rich on top end at fast idle sometimes it will drop to a very low idle and shut off adjust the idle mixture screws first and then adjust the ...

...idle adjustment screw. Here's a general guide: Locate the Idle Adjustment Screw: It's usually located near the carburetor or throttle body. On the Honda Fury, it might be located on the side of the ...

...adjustment can help balance the fuel-to-air ratio for both cylinders. Here are the steps you can follow: Idle Screw (Air/Fuel Mix): The idle screw, also known as the pilot screw, adjusts the air/fuel ...

...idle adjustment on the carb. There are 2 screw type adjustments there, one is the idle/air screw and the other is idle adjustment which is the one you want. Start the bike and warm.it up, slowly turn ...

...idle speed adjustment, the other is the idle mixture adjustment). Turn the idle mixture adjustment screw in or out until the fastest idle speed is attained. Then adjust the idle speed with the idle ...

yamaha serow i have just had the valves adjusted on my serow and since then it idles very slow when cold and as the motor heats up the idle revs higher as well until it idles to fast HAVE VALVES RE ...

...if it was idling fine before, and the idle mixture adjustment hasn't been changed, then do a compression check, first. To idle properly, each cylinder's compression needs to be at least 140